Plate made of Epoxy resin paper for soldering capacitors, resistors, diodes ... in amplifier manufacturing projects. Its measurements are approximately 77mm by 32mm with two rows of 6 turrets each.

ON REQUEST! ESTIMATED DELIVERY 5 TO 31 WORKING DAYS!

Plate made of Epoxy resin paper to solder capacitors, resistors, diodes ... in manufacturing projects of Fender Champ model 5F1 clone amplifiers. Its measurements are 150mm by 70mm and it has 20 turrets.

Made in China.

ON REQUEST! ESTIMATED DELIVERY 5 TO 31 DAYS!

EYELETBOARD, tweed filter supply board 5F6-A Bassman, 5F8-A High Power Twin 

Eyelet board for the electrolytic capacitors in the power supply of the Fender Amps with the 5F6, 5F6-A, 5F8 and 5F8-A circuit.

These are the TWEED Fender Bassman and Tweed Twin Amp of the later 1950s. 

this board is the same as we use in our TAD Amp-Kits for the 5F6 and 5F8 models. 

Dimension: 101mm x 76mm

Plate made of Epoxy resin paper for soldering capacitors, resistors, diodes ... in Marshall 18W clone amplifier manufacturing projects. Its measurements are 255mm by 60mm and it has 45 turrets.

Made in China.

Plate made of Epoxy resin paper to solder capacitors, resistors, diodes ... in manufacturing projects of clone amplifiers of the Marshall JTM45. Its measurements are 258mm by 76mm.

ON REQUEST! ESTIMATED DELIVERY 5 TO 31 WORKING DAYS!

Plate made of Epoxy resin paper for soldering capacitors, resistors, diodes ... in manufacturing projects of Fender Tweed Deluxe model 5E3 clone amplifiers. Its measurements are 230mm by 70mm.

ON REQUEST! ESTIMATED DELIVERY 5 TO 31 DAYS!

Made in the traditional way as used by Fender since the 50s till the 70s.

ON REQUEST! ESTIMATED DELIVERY 5 TO 31 WORKING DAYS!

Turret board with pre installed turrets designed to be used to build a 5F6A layout or variants. Includes the required 2 pieces.

2mm board

5F6A Layout

Includes 2 pieces