SOVIET PAPER IN OIL CAPACITOR PIO K40Y-9 0.047uF 400V STRATOCASTER TELECASTER

Acts as a normal volume or tone control, and pulls up to activate its on / on double-pole double throw mini switch. Controls pickup phasing, series / parallel switching and coil-taps- Split shaft with coarse knurling. Two mounting nuts, flat washer and lock washer included.

CAUTION: In some Les pauls, Este potentiometer can be very large.

Set of 2 non-original buttons for Gibson , Epiphone or other Epiphone made in the USA. These buttons can only be used in those potentiometers of American measurements (not metric or oriental!) Of brands such as Bourns , CTS or PEAC among other manufacturers ("24 pin inch type for knurled shaft"). Great value for the price.

The best kit to avoid losing treble when lowering the volume of your guitar especially in single coil pickups! This kit is comprised of premium American-made electronic components: a 0.0012uF Sprague Orange Drop capacitor and a 130k 1 / 2W Allen Bradley resistor.

This SPST ON / OFF switch isn't a 1: 1 direct replacement. It does not fit perfectly into the hole of the TS-9 series pedals and more. Although the switch does not snap in it fits in the pedal securely and tightly. Switching is 100% reliable. The advertised solution is absolutely road tested.

Used in the Ibanez 9-series effects pedals (eg TS9, AD9, etc). Size: 12x12x7,3mm.

20 high quality chrome pickguard screws, jack plates or backs for Fender Stratocaster, Telecaster and similar guitars.

Measures 3x12mm

Oak Grigsby brand original five-position selector for Fender Stratocaster guitars and all those guitars that also request a selector of these characteristics. It is a high quality position selector that will provide you with greater performance and a low noise level.

Genuine and authentic Sprague brand capacitors imported from Mexico, ideal for all types of basses and guitars of any brand. With this condenser, you will get a softer and warmer tone than other ceramic condensers. On YouTube and on the Internet you can check the quality of this article.

Authentic and genuine Sprague Orange Drop 418P 600V series capacitors (polyester) made in the USA. They are the condensers preferred by technicians around the world who repair vintage amplifiers from brands such as Fender , Ampeg , Magnatone, Marshall , Valco among many other brands. They are also ideal for HI-FI stereos, vintage radios, and on your Gretsch guitar.

These two capacitors are ideal for use on your Gibson Les Paul, SG, Explorer ... guitar to achieve Eric Clapton's famous "WOMAN TONE" sound. For very little money, imitate the sound of your idols!

Mini toggle switch DPDT ON-ON. With this mini switch you can do "series / parallel pickup switching", "phase switching" and "humbucker coil tapping" to all the guitars on the market.

10 high quality chrome screws and the correct size for Gibson Les Paul Guitar Truss Rods and the like.

Measurements: 2 x 1/4 in.

Emerson Pro CTS pots from Emerson Custom were designed to be the premium choice for the discerning guitarist looking for the optimum performance and tonal response from a guitar potentiometer. These specially designed Emerson Pro CTS feature a longer-life brass shaft and bushing. They also feature a tighter ± 8% resistance tolerance compared to CTS products offered by most other suppliers.

Potentiometer for controlling the volume or tone of active pickups, or for use after the preamp of a piezo-saddle electric guitar bridge. Made by CTS .

Excellent quality single-core cables with 1 meter BROWN and 1 meter RED color cotton coating type "Vintage" and single conductor, to wire any brand of guitar or bass on the market: Fender , Gibson , Ibanez , Jakson, Rickenbacker .. The cables can also be used to wire a combo or display or to make the typical old amp braided cable.

"6-32 X 3/4" "PHILLIPS PAN HEAD NICKEL. This screw is used for height adjustment of single coil US pickups. It will work for many import pickups but some use a very small hole that may have to be opened up. With springs included.

High quality potentiometer manufactured by Bourns ideal for Gibson , Epihone or similar guitars. The measurements are the same as the CTS Long Shaft model 450GT.
Measurements:

Total pot depth - 40mm

Length of threaded shaft - 9mm

Shaft diameter - 9.5mm

Base of pot diameter - 23.5mm

Authentic and genuine Switchcraft brand model # 11 jacks. Great for use on guitars, effects pedals, and amps. Very hard and resistant and with a quality proven for many years. Inside the jack, the manufacturer's brand is screen-printed and the washer and its corresponding nut are included.

Excellent quality single-core cables with 1 meter WHITE and 1 meter BLACK "Vintage" color cotton coating and single conductor, to wire any brand of guitar or bass on the market: Fender , Gibson , Ibanez , Jakson, Rickenbacker .. The cables can also be used to wire a combo or display or to make the typical old amp braided cable.

Authentic and genuine Switchcraft brand model #12A jacks. Great to use on your guitar, your effects pedals although it can be used without problems in amplifiers. Very hard and resistant and with a quality proven for many years. Inside the jack, the manufacturer's brand is screen-printed and the washer and its corresponding nut are included.

20 high quality gold plated pickguard, jack plate or back screws for Fender Stratocaster, Telecaster and similar guitars.

Measurements: 3X12mm

Authentic and genuine tin from the German brand Mundorf with one of the highest qualities you can find on the market. Ideal for HI-FI equipment, musical instruments, amplifiers ... that require quality welding.

Excellent quality monofilament cable with YELLOW cotton coating "Vintage" type, to wire any brand of guitar or bass on the market: Fender , Gibson , Ibanez , Jakson, Rickenbacker ... The cable can also be used to wire a combo or a screen or to make the typical old amp braided cable.

New and unused input jack for Gibson , Epiphone and some Telecaster model guitars. They come included with the front, the jack, the washer, the nuts and the four screws to hold them. The front has a slight curve for those guitars that need it.

LAST UNITS FOR SALE! IT IS THE MOST SEARCHED CAPACITOR BECAUSE THE BEING 400V GIVES A MORE SPECIAL TONE THAN THOSE OF 200, 630 OR 1000 VOLTS. THERE ARE FEW UNITS WORLDWIDE.

The best push-pull potentiometer ever made! These aren't your standard off the shelf CTS pots either. Mojotone had them custom made to their specification to have the smoothest taper possible and the tightest tolerance available!

Switchcraft mono end pin. 15/32 "dia. 1/2" mounting hole. For acoustic and active electronics guitars. Turns on battery when plug is inserted. With nut, washer and the brand Switchcraft serigraphed. MADE IN USA

5 original Switchcraft brand nuts, 5 plain washers and 5 lock washers to use on various models of your jacks. They can also be used in potentiometers made in the United States or Canada ( CTS , Bourns , PEC ..) because they are American metric. 15 items are sent as they appear in the photo.

Capacitors of military origin that were used for military equipment of the former Soviet Union and that were rediscovered as one of the best capacitors for audio thanks to its good finish, its very precise specifications and its properties when used in guitars, basses, amplifiers of recognized brands, Danny Gatton, HI-FI equipment etc ...

Mini toggle switch DPDT ON-ON manufactured by the Carling brand. With this mini switch you can make "series / parallel pickup switching", "phase switching" and "humbucker coil tapping" to all guitars on the market.

Original Dunlop brand ECB035 DPDT footswitch for use on MXR and Dunlop effect pedals. It is not compatible with the other ECB555 foot switch model! They are sold in their original bag and hermetically closed.

Original Fender buttons for Fender Telecaster and Precision Bass guitars. Path Number: 0991366000

3-way selector made by the Electroswitch company in the United States, famous for its high resistance to use, almost 0% noise and its ease to solder the cables in it. This brand of selector has been around since the early days of the electric guitar and is the best you can find on the market today.

Guitar volume and tone pot - the top-of-the-range 450 series CTS Premium 500k long shaft pot. Audio (log) taper. This pot is ideal for instruments with humbuckers pickups. CTS pots have been used in countless electric guitars since Fender and Gibson started using them in the early '60s.

Potentiometer made for electric guitars with a very thin thickness or a very tight gap where size is an issue. With great quality, a smoother and more precise turn than the other 16mm potentiometers that we sell in our store. A washer and a nut are included.

Excellent quality monofilament cables with WHITE cotton coating type "Vintage" and single conductor, to wire any brand of guitar or bass on the market: Fender , Gibson , Ibanez , Jakson, Rickenbacker ... The cable can also be used to wire a combo or display or to make the typical old amp braided cable. The diameter is .070 ".

Treble bleed kit for Fender Stratocaster of all eras. It consists of a CRL capacitor with a capacity value of 0.0025uF of the famous "Z5U" models and a 1 / 2W 220K resistor from Allen Bradley, all of it NOS or "New Old Stock".

With this kit you will maintain the tone and volume with more consistency when you turn the potentiometer down.

Set of two non-original buttons for Gibson , Epiphone or other brands Epiphone made in South Korea. This button can only be used in those potentiometers of American measures (not metric!) Of brands such as Bourns , CTS or PEAC among other manufacturers ("24 pin inch type for knurled shaft"). Great value for the price.

Set of two reissued buttons of the old ones that used the Harmony or Silver tone guitars. These buttons only fit perfectly on CTS or Emerson Custom Guitars "Split Shaft" potentiometers on models such as 450GT, EPXXXX, mini, left hand or Push-Pull (all other brands or metric sizes drop or adjust too slightly to the stem)

Authentic and genuine Switchcraft brand model #12B jacks. Great to use on your guitar, your effects pedals although it can be used without problems in amplifiers. Very hard and resistant and with a quality proven for many years. Inside the jack, the manufacturer's brand is screen-printed and the washer and its corresponding nut are included.

Excellent quality single-core cables with 1 meter YELLOW and 1 meter BLACK "Vintage" color cotton coating and single conductor, to wire any brand of guitar or bass on the market: Fender , Gibson , Ibanez , Jakson, Rickenbacker .. The cables can also be used to wire a combo or display or to make the typical old amp braided cable.

Switchcraft 152B jack - Stereo end pin. 15/32 "dia. 1/2" mounting hole. For acoustic and active electronics guitars. Turns on battery when plug is inserted. With nut, washer and the brand Switchcraft serigraphed. MADE IN USA

Genuine and authentic Sprague brand capacitors imported from Mexico, ideal for all types of guitars with single coils of any guitar brand but especially the Fender brand. With this condenser, you will get a softer and warmer tone than other ceramic condensers.

The Fralin Magic Cap is a .0015 Capacitor of Sprague Orange Drop that Lindy swears by. When activated, your plain strings will sound thicker and larger - immediately. This Cap is perfect for anyone looking to add a bit more functionality to their guitar, but doesn't need a ton of highs rolled off.

High quality potentiometer manufactured by Bourns ideal for Gibson , Epihone or similar guitars. The measurements are the same as the CTS Long Shaft model 450GT.
Measurements:

Total pot depth - 40mm

Length of threaded shaft - 9mm

Shaft diameter - 9.5mm

Base of pot diameter - 23.5mm

Original Fender brand buttons for Jazz Bass. Path Number: 0991370000

Excellent quality single-core cable with BLUE cotton coating "Vintage" type, to wire any brand of guitar or bass on the market: Fender , Gibson , Ibanez , Jakson, Rickenbacker ... The cable can also be used to wire a combo or a screen or to make the typical old amp braided cable. The diameter is .070 ".

Switchcraft original button for pickup selectors of the same brand. It has a quality of finish superior to the generic ones that makes it essential if your Gibson guitar has a certain value so as not to clash with the unique aesthetics of this guitar manufacturer.

3-way selector made by the Electroswitch company in the United States, famous for its high resistance to use, almost 0% noise and its ease to solder the cables in it.