CTS 500K A500K DPDT PUSH-PULL SHORT SPLIT SHAFT MOJOTONE

Authentic and genuine Sprague Orange Drop 225P series (polyester) capacitors made in the USA. They are the condensers preferred by technicians around the world who repair vintage amplifiers from brands such as Fender , Ampeg , Magnatone, Marshall , Valco among many other brands. Ideal for basses and guitars.

CTS pots with a shorter ¼ ”bushing length that is perfect for pickguard mounted pots. These pots reduce the gap between the pickguard and bottom of the knob for a clean, near flush look. The shaft is a fine (24 tooth) knurl. Nut and lock washer are included.

Guitar volume and tone pot - the top-of-the-range 450 series CTS Premium 500k split shaft pot. Audio (log) taper. This pot is ideal for instruments with humbuckers pickups. CTS pots have been used in countless electric guitars since Fender started using them in the early '60s.

10 high quality black pickguard screws, jack plates or backs for Fender Stratocaster, Telecaster and similar guitars.

Measurements: 3X12mm

Guitar volume and tone pot - the top-of-the-range 450 series CTS Premium 500k split shaft pot. Linear taper. This pot is ideal for instruments with humbuckers pickups. CTS pots have been used in countless electric guitars since Fender started using them in the early '60s. Split shaft for push-fit knobs.

Mini toggle switch DPDT ON-ON manufactured by the Carling brand. With this mini switch you can make "series / parallel pickup switching", "phase switching" and "humbucker coil tapping" to all guitars on the market.

The Pure Tone jack contains dual tension grounds and dual positive tips for optimal signal and lowest possible noise. 100% greater surface area at all contact points creates a more stable connection; as a result, high and low frequencies are greatly improved creating a much more balanced sound while eliminating frequency spikes. No more noise crackle caused by pressure grounds!

Original Fender brand pickup covers for Stratocaster guitars and similar. Path Number: 0991364000

Authentic and genuine tin from the German brand Mundorf with one of the highest qualities you can find on the market. Ideal for HI-FI equipment, musical instruments, amplifiers ... that require quality welding.

High quality 9V battery holder for use in various models of electric guitars and basses with active pickups. No battery or battery clips or screws are included.

Dimensions: Approximately 85mm (L) x 32mm (W) x30mm (H)

Material: ABS

Pot for controlling one pickup or source to another, with both signals full at the center detent. Audio or Linear Taper with split shaft.

This Japanese New OLD STOCK ceramic capacitor will be used to make the treble bleed or "treble bleed" on your PRS guitar.

Mini DPDT ON-ON-ON toggle switch with six gold pins. With this mini switch you can make "series / parallel pickup switching", "phase switching" and "humbucker coil tapping" to all guitars on the market.

Acts as a normal volume or tone control, and pulls up to activate its on / on double-pole double throw mini switch. Controls pickup phasing, series / parallel switching and coil-taps- Split shaft with coarse knurling. One mounting nut and flat washer included. Measures metric for Japan, China or Korea Guitars!

Capacitors of military origin that were used for military equipment of the former Soviet Union and that were rediscovered as one of the best capacitors for audio thanks to its good finish, its very precise specifications and its properties when used in guitars, basses, amplifiers of recognized brands, Danny Gatton, HI-FI equipment etc ...

Button for use on 18-pin Split Shaft rotary switches. It can also be used on 1950s guitars or effect pedals.

Excellent quality monofilament cables with WHITE cotton coating type "Vintage" and single conductor, to wire any brand of guitar or bass on the market: Fender , Gibson , Ibanez , Jakson, Rickenbacker ... The cable can also be used to wire a combo or display or to make the typical old amp braided cable. The diameter is .070 ".

The Super Pots from Dunlop are high quality, high performance, volume and tone pots designed and built to last a lifetime. These pots are resistant to dust and corrosion so they will provide smooth performance without the noise and scratchiness associated with normal run of the mill pots.

The best kit to not lose treble when you lower the volume of your guitar! This kit consists of premium electronic components (NOS) made in the United States and the former Soviet Union: a 680pF Paper in Oil or PIO K40Y-9 capacitor and a 220K 1 / 2W Allen Bradley resistor. This kit is designed in the style of Acme Guitar Works (in parallel).

Original Switchcraft brand switch (short size) for Gibson and Epiphone . This article will give you the sound and quality you are looking for for your guitar. Made in the United States and imported. The original Switchcraft black hood or hood is included.

The best push-pull potentiometer ever made! These aren't your standard off the shelf CTS pots either. Mojotone had them custom made to their specification to have the smoothest taper possible and the tightest tolerance available!

Genuine and authentic Sprague brand capacitors imported from Mexico, ideal for all types of guitars with single coils of any guitar brand but especially the Fender brand. With this condenser, you will get a softer and warmer tone than other ceramic condensers.

20 high quality gold plated pickguard, jack plate or back screws for Fender Stratocaster, Telecaster and similar guitars.

Measurements: 3X12mm

Chrome black three-position selector switch with black button or cap and made of plastic. This selector is very popular on Gibson or Epiphone made outside of the United States. The washer and the nut are included.

Excellent quality single-core cables with 1 meter WHITE and 1 meter RED color cotton coating, "Vintage" type and single conductor, to wire any brand of guitar or bass on the market: Fender , Gibson , Ibanez , Jakson, Rickenbacker .. The cables can also be used to wire a combo or display or to make the typical stranded old amp cable.

This American condenser is special because it has an "anti-corona" coating with a wax impregnation that allows the condenser to be much less noisy than a few cents, making it one of the best on the market.

10 high quality chrome screws and the correct size for Gibson Les Paul Guitar Truss Rods and the like.

Measurements: 2 x 1/4 in.

Authentic and genuine Sprague Orange Drop 225P series (polyester) capacitors made in the USA. They are the condensers preferred by technicians around the world who repair vintage amplifiers from brands such as Fender , Ampeg , Magnatone, Marshall , Valco among many other brands.

20 high quality chrome pickguard screws, jack plates or backs for Fender Stratocaster, Telecaster and similar guitars.

Measures 3x12mm

These are the best quality CTS pots available right now. 

White 3-position switch for Fender Stratocaster and Telecaster guitars. The screws and the hood are included (it is white but has a slight yellow hue) as shown in the photos.

Pot for controlling one pickup or source to another, with both signals full at the center detent. Audio or Linear Taper with split shaft.

Acts as a normal volume or tone control, and pulls up to activate its on / on double-pole double throw mini switch. Controls pickup phasing, series / parallel switching and coil-taps- Split shaft with coarse knurling. One mounting nut and flat washer included. Measures metric for Japan, China or Korea Guitars!

The best push-pull potentiometer ever made! These aren't your standard off the shelf CTS pots either. Mojotone had them custom made to their specification to have the smoothest taper possible and the tightest tolerance available!

The 2-pole and 3 position switch can be used in guitars. Hardware included. Made by Alpha .

Acts as a normal volume or tone control, and pulls up to activate its on / on double-pole double throw mini switch. Controls pickup phasing, series / parallel switching and coil-taps- Split shaft with coarse knurling. One mounting nut and flat washer included. Measures metric for Japan, China or Korea Guitars!

Pickup selector trim for Gibson and Epiphone ivory or cream color. They are brand new and unused.

ATTENTION: THIS COVER IS NOT VALID FOR THOSE GUITARS THAT USE SWITCHCRAFT MA RCA SELECTORS. IF YOU WANT ANY OF THIS MA RCA VISIT OUR STORE.

Set of 2 non-original buttons for Gibson , Epiphone or other brands Epiphone made in South Korea. This button can only be used in those potentiometers of American measures (not metric!) Of brands such as Bourns , CTS or PEAC among other manufacturers ("24 pin inch type for knurled shaft"). Great value for the price.

Excellent quality single-core cables with 1 meter WHITE and 1 meter BROWN color cotton coating "Vintage" type and single conductor, to wire any brand of guitar or bass on the market: Fender , Gibson , Ibanez , Jakson, Rickenbacker .. The cables can also be used to wire a combo or display or to make the typical stranded old amp cable.

Excellent quality single-core cables with 1 meter RED and 1 meter BLACK "Vintage" color cotton coating and single conductor, to wire any brand of guitar or bass on the market: Fender , Gibson , Ibanez , Jakson, Rickenbacker .. The cables can also be used to wire a combo or display or to make the typical stranded old amp cable.

Original Fender buttons for Stratocaster model guitars. Path Number: 0991365000

Short screws used to secure a short (neck position) humbucker mounting ring on to a guitar (Pack 4 units)

Button adapted to the measurements of Switchcraft pickup selectors made in the United States. It does not fit well on Chinese, Korean, Japanese or Mexican guitars that have position switches with metric or "metric" measurements!

If you want an original Switchcraft button visit our store.

New Production - Made in the USA

Constructed with the finest materials. Comparable to the famous and sought after Vintage Sprague Vitamin Q Capacitors.

Set of 2 non-original buttons for Gibson , Epiphone or other brands Epiphone made in South Korea. This button can only be used in those potentiometers of American measures (not metric!) Of brands such as Bourns , CTS or PEAC among other manufacturers ("24 pin inch type for knurled shaft"). Great value for the price.

Acts as a normal volume or tone control, and pulls up to activate its on / on double-pole double throw mini switch. Controls pickup phasing, series / parallel switching and coil-taps- Split shaft with coarse knurling. Two mounting nuts, flat washer and lock washer included.