BOURNS AUDIO A500K 500K PUSH/PULL CONTROL TONE POT SHORT SHAFT FOR GIBSON

If you hate that external noises such as power supplies, televisions, fluorescents, radio broadcasts etc ... make your guitar or bass sound terrible and engage annoying sounds, Electrónica Baile offers you the most practical solution to avoid those unwanted noises especially when you play with distortion.

20 high quality chrome pickguard screws, jack plates or backs for Fender Stratocaster, Telecaster and similar guitars.

Measures 3x12mm

Genuine Dunlop inductor for use in wah wah even from Vox brand. It is said that the first wah wah had an inductor just like this at the base of the pedal that made it sound so good. This inductor has a direct impact on the harmonics generated by saturation, since it clips asymmetrically. Hence, its sound is more "musical" and with better quality.

Original Switchcraft brand switch (short size) for Gibson and Epiphone . This article will give you the sound and quality you are looking for for your guitar. Made in the United States and imported. Hood or hood is not included!

These two capacitors are ideal for use on your Gibson Les Paul, SG, Explorer guitars... to achieve Eric Clapton's famous "WOMAN TONE" sound. For very little money, imitate the sound of your idols!

Acts as a normal volume or tone control, and pulls up to activate its on / on double-pole double throw mini switch. Controls pickup phasing, series / parallel switching and coil-taps- Split shaft with coarse knurling. Two mounting nuts, flat washer and lock washer included.

Acts as a normal volume or tone control, and pulls up to activate its on / on double-pole double throw mini switch. Controls pickup phasing, series / parallel switching and coil-taps- Split shaft with coarse knurling. Two mounting nuts, flat washer and lock washer included.

Acts as a normal volume or tone control, and pulls up to activate its on / on double-pole double throw mini switch. Controls pickup phasing, series / parallel switching and coil-taps- Split shaft with coarse knurling. One mounting nut and flat washer included. Measures metric for Japan, China or Korea Guitars!

The best push-pull potentiometer ever made! These aren't your standard off the shelf CTS pots either. Mojotone had them custom made to their specification to have the smoothest taper possible and the tightest tolerance available!

Want to get the sound of Tom Morello, Jack White or Buckethead? Well now you have it much easier with this button that you can insert into your guitar just by making a hole and wiring it according to the diagrams that run on the Internet.

The Pure Tone jack contains dual tension grounds and dual positive tips for optimal signal and lowest possible noise. 100% greater surface area at all contact points creates a more stable connection; as a result, high and low frequencies are greatly improved creating a much more balanced sound while eliminating frequency spikes. No more noise crackle caused by pressure grounds!

Bourns brand potentiometer made for guitars or basses that have a very small gap or thickness. High quality with a tolerance of ± 20 %. With a very smooth twist. PDB241 series.

Dimensions:

The best kit to avoid losing treble when lowering the volume of your guitar especially in single coil pickups! This kit is made up of premium quality electronic components made in Mexico: a 0.002uF 6PS Sprague Orange Drop capacitor and a 130k 1 / 2W Allen Bradley resistor.

If you know anything about Paul Reed Smith (PRS) guitars, you know there are a surprising number of possibilities available through the use of rotary switches. Further, you can use these for switching combinations within a pickup or between several pickups.

Guitar volume and tone pot - the top-of-the-range 450 series CTS Premium 500k split shaft pot. Linear taper. This pot is ideal for instruments with humbuckers pickups. CTS pots have been used in countless electric guitars since Fender started using them in the early '60s. Split shaft for push-fit knobs.

A black-gold double-pole 3-way switch, popular in guitars made outside the USA. Fits 2-pickup guitars. Knurled mounting nut, flat washer, and black, chrome and cream plastic knobs are included.

Dimensions:

Overall height is 2 "(50mm)
7/8 '(23.5mm) mounting depth with almost 3/8 "(9mm) threaded section.
Fits 1/2 "mounting hole diameter.

Capacitors of military origin that were used for military equipment of the former Soviet Union and that were rediscovered as one of the best capacitors for audio thanks to its good finish, its very precise specifications and its properties when used in guitars, basses, amplifiers of recognized brands, Danny Gatton, HI-FI equipment etc ...

Capacitors of military origin that were used for military equipment of the former Soviet Union and that were rediscovered as one of the best capacitors for audio thanks to its good finish, its very precise specifications and its properties when used in guitars, basses, amplifiers of recognized brands, Danny Gatton, HI-FI equipment etc ...

Authentic and genuine Sprague Orange Drop 225P series (polyester) capacitors made in the USA. They are the condensers preferred by technicians around the world who repair vintage amplifiers from brands such as Fender , Ampeg , Magnatone, Marshall , Valco among many other brands.

Guitar and bass volume and tone pot. Audio (REVERSE log) taper for LEFT HAND (SOUTHPAW). This pot is ideal for instruments with humbuckers pickups. CTS pots have been used in countless electric guitars since Fender started using them in the early '60s. Split shaft for push-fit knobs

Bourns brand potentiometer made for guitars (PDB181-GTR series) that have a very small gap or thickness. High quality with a tolerance of ± 20 %. A washer and a nut are included.

Guitar and bass volume and tone pot. Audio (REVERSE log) taper for LEFT HAND (SOUTHPAW). This pot is ideal for instruments with humbuckers pickups. CTS pots have been used in countless electric guitars since Fender started using them in the early '60s. Split shaft for push-fit knobs.

Authentic and genuine Switchcraft brand model # 11 jacks. Great for use on your Fender guitar or effect pedals, but can be used on amps without any problems. Very hard and resistant and with a quality proven for many years. Inside the jack, the manufacturer's brand is screen-printed and the washer and its corresponding nut are included.

The JJ ECC81 / 12AT7 tube is a low noise and low microphonic preamp tube. A good choice for phase inverters and reverb circuits calling for 12AT7 tubes.

The ECC81 tube type is equivalent to the North American 12AT7 tube and can be used in any 12AT7 or ECC81 circuit.

High quality stereo jack for use on electric guitars and electric basses.

ON REQUEST! ESTIMATED DELIVERY 4 TO 31 WORKING DAYS!

Bourns brand potentiometer made for guitars (PDB181-GTR series) that have a very small gap or thickness. High quality with a tolerance of ± 20 %.
Measurements:

Total length from base to stem - 30mm

Screw-in shaft length - 11mm

Diameter length for the "Knob" - 10mm

Base diameter - 16mm

Bourns brand potentiometer made for guitars or basses that have a very small gap or thickness. High quality with a tolerance of ± 20 %. A washer and a nut are included. With a very smooth twist. PDB241 series.

Measurements:

Total length from base to stem - 30mm
Screw-in shaft length - 11mm
Diameter length for the "Knob" - 10mm
Base diameter - 24mm

Want to get the sound of Tom Morello, Jack White or Buckethead? Well now you have it much easier with this button that you can insert it into your guitar just by making a hole and wiring it according to the diagrams that run on the Internet.

Genuine and authentic Sprague brand capacitors imported from Mexico, ideal for all types of guitars with single coil pickups of any brand of guitar but especially for Fender . With this condenser, you will get a softer and warmer tone than other ceramic condensers. MADE IN USA! 100% GUARANTEED! DON'T PLAY WITH CHEAP COPIES!

The best kit to avoid losing treble when lowering the volume of your guitar especially in single coil pickups! This kit is comprised of premium American-made electronic components: a 0.0012uF Sprague Orange Drop capacitor and a 130k 1 / 2W Allen Bradley resistor.

Original Switchcraft brand switch (short size) for Gibson and Epiphone . This article will give you the sound and quality you are looking for for your guitar. Made in the United States and imported. Included is the original Switchcraft ivory or cream hood or hood.

Acts as a normal volume or tone control, and pulls up to activate its on / on double-pole double throw mini switch. Controls pickup phasing, series / parallel switching and coil-taps- Split shaft with coarse knurling. Two mounting nuts, flat washer and lock washer included.

CAUTION: In some Les pauls, Este potentiometer can be very large!

Guitar volume and tone pot - the top-of-the-range 450 series CTS Premium 500k split shaft pot. Audio (log) taper. This pot is ideal for instruments with humbuckers pickups. CTS pots have been used in countless electric guitars since Fender started using them in the early '60s.

This American condenser is special because it has an "anti-corona" coating with a wax impregnation that allows the condenser to be much less noisy than a few cents, making it one of the best on the market.

The best kit to make yourself the legendary "Varitone". Get more sounds with this kit composed of an Alpha brand rotary switch (2 poles and 6 positions) and the famous Sprague Orange Drop model 225P capacitors.

This Japanese New OLD STOCK ceramic capacitor will be used to make the treble bleed or "treble bleed" on your PRS guitar.

Mallory 150M Series condenser ideal for all types of guitars with single coil pickups. This capacitor is the same one you can find in the PRS or Paul Reed Smith.

The best kit to avoid losing treble when lowering the volume of your guitar especially in single coil pickups! This kit is comprised of premium quality electronic components made in Mexico: a 0.002uF 6PS Sprague Orange Drop capacitor and a 100k 1 / 2W Allen Bradley resistor.

New Production - Made in the USA

Constructed with the finest materials. Comparable to the famous and sought after Vintage Sprague Vitamin Q Capacitors.

Excellent quality single-core cables with 1 meter RED and 1 meter BLACK "Vintage" color cotton coating and single conductor, to wire any brand of guitar or bass on the market: Fender , Gibson , Ibanez , Jakson, Rickenbacker .. The cables can also be used to wire a combo or display or to make the typical stranded old amp cable.

Genuine Fender replacement knob plus cap for S-1 switch. Fits 1/4 "split shaft controls. The S-1 switch can be retrofitted to nearly any Stratocaster (US and Mexico) produced from 1954-Present.

Pack of 2 items (1 knob + 1 cap).

Black 5-position switch for Fender Stratocaster and Telecaster guitars. The hood is included as shown in the photos.

Genuine and authentic Sprague brand capacitors imported from Mexico, ideal for all types of guitars with single coils of any guitar brand but especially the Fender brand. With this condenser, you will get a softer and warmer tone than other ceramic condensers.

Mallory 150 M Series capacitors are made of metallized polyester film with only a 5% tolerance. They are the condensers preferred by technicians the world over for their quality, performance and pure "vintage" sound. They are ideal for repairs, upgrades, or new projects on guitar or audio amplifiers.